DRV8825 Schrittmotor Treiber Board für 3D Drucker, CNC, RepRap RAMPS inkl. Kühlkörper für z.B Arduino, Raspberry Pi Projekte
The DRV8825 stepper motor driver carrier board TI DRV8825 micro bipolar stepper motor drive is a breakthrough.
The module has a pinout and interface with our A4988 stepper motor driver carrier is almost the same,
so it can be used as a better performance of the pull-down menu board replacement in many applications.
DRV8825 features an adjustable current limit, overcurrent and overtemperature protection,
six micro-resolution (down 1/32-step). It uses 8.2 - 45 V, can provide up to about 1.5 per phase no heat sink or
forced air flow rated up to 2.2 per volume sufficient additional cooling).
Product Features:
A simple steps and direction control interface
six different steps resolutions: full step, half step, 1/4-step1/8-step1/16-step, 1/32-step
CAN interface directly with 3.3 V and 5 V systems
Over-temperature thermal shutdown, overcurrent shutdown, undervoltage lockout
short to ground short circuit load protection
4 Layer 2 oz copper PCB, in order to improve heat dissipation
exposed solder ground below the bottom of the driver IC on the printed circuit board pad
module size, pin and interface matching A4988 stepper motor driver operators in many ways
adjustable current control lets you set a potentiometer, which lets you use the stepper motor's rated voltage or more,
in order to achieve a higher rate of maximum output current step
Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay)
Maximum 45 V supply voltage
built-in voltage regulator (the need for any external logic supply voltage)
Incl. our heatsink with sticker, so easy to use
Ab Lager lieferbar
plus Versand via Warensendung 1,50€ oder Maxibrief 2,50€
Zahlung via Vorab-Überweisung oder PayPal möglich
Persönliche Abholung nach vorheriger Terminabsprache auch möglich, bitte einfach anrufen